M.2 NGFF TO SATA 3.0 SSD Enclosure (SSD not included)

Suitable for SATA protocol 2242/2260/2280mm M.2 NGFF SSD (only support SATA protocol B Key and B+M Key NGFF M.2, not support Nvme PCIE protocol M Key/b+M Key M.2 and mSATA SSD)

How to Use:

Received the adapter card SSD adapter box, key open the shell, use a screwdriver to unscrew the back of the PCBA board screws, load SSD disk, diagonal 45 degrees aligned with a good interface to insert the hard disk, hard disk card in the big screws at the waist, gently press the hard disk lock screws can be, the shell for the tool-free installation, fasten the shell 4 corners of the flat that is, the installation is complete (Warm Tips: If you need to open the shell, pay attention to the side of the 4 holes, with a small screwdriver or a cotton swab to reach into each hole position from the bottom to the top of each hole to the top, 4 buckle points will be loosened to open it) Cotton swabs into each hole from the bottom to the top of each hole into the top a little, 4 buckle point will be loosened to open it)

Attention:

1. new hard drive use, you need to first go to “My Computer” “Management” in the hard disk format before you can out of the disk, do not know how to format the hard disk can consult the hard disk business or Baidu query formatting method to complete the formatting of the partition can be used normally (the old disk to cut into the operation) Formatting, otherwise the data will be lost, for the safety of your data, it is recommended that you backup your data before use in case of emergency)
2. This adapter box does not drop the speed does not slow down, directly into the computer SATA3.0 interface, the state is the best!