Repair Service Ge Control WB27T10063 and similar items

the common failure symptoms ???1. The "F1" Error Code (Most Common) ?This is the single most frequent failure indicator for this series. ?The Symptom: The display flashes "F1" and often beeps continuously. ?The Cause: This code signals a "Keypad Stuck" or internal memory error. It means the board thinks a button is being pressed permanently. ?Crucial Diagnostic: To determine if it is the board or the touch panel (overlay), you can disconnect the ribbon cable connecting the keypad to the board and power it back on. ?If the F1 code returns while the keypad is unplugged, the control board (WB27T100xx) is bad. ?If the F1 code stops, the touchpad/overlay is bad, not the board. ?2. Erratic Temperature Control ?Runaway Heat: The oven heats far beyond the set temperature (e.g., you set it to 350F, but it climbs to 500F+ and burns the food). This indicates a stuck relay on the board. ?Failure to Reach Temp: The oven turns on but never reaches the target temperature, or it stops heating randomly during the cycle. PLEASE READ BEFORE PURCHASING THIS IS A MAIL-IN REPAIR SERVICE ONLY. You are NOT buying a new circuit board. ?INSTRUCTIONS: ?Buy this service. ?We will message you our SHIPPING ADDRESS. ?You mail your broken board to us for repair. ?WHY CHOOSE US? We have proudly served the community for 19 years, delivering fast, reliable, and professional repairs. ?BOARD REQUIREMENTS POLICY: The board we receive must be in good physical condition and must not have been tampered with or serviced before (no traces of previous repair attempts). ?IMPORTANT ? PLEASE NOTE: If we receive a board that: ?Has been tampered with or previously attempted to be repaired, OR ?Is tested and found to be in good working order (no repair needed). ?The buyer will be responsible for the following non-refundable charges: ?A $20.00 Bench Test/Diagnostic Fee. ?The cost of Return Shipping. ?All applicable and PayPal fees associated with the transaction.