NSEE PY600 AC Residential Rack & Pinions and 16 similar items

Package 2 Includes: 1. Sliding Gate Operator (1) (Set) (110v). 2. Remote Controller (2) (PCs). 3. Internal Hex-angular Bolt (4) (PCs). 4. Internal Hex-angular Bolt (4) (PCs). 5. Left Limit Iron (1) (PCs). 6. Right Limit Iron (1) (PCs). 7. Base (1) (PCs). 8. Release Keys (2) (PCs). 9. Manual (1) (PCs). 10. 15ft of Steel Rack (5 PCs). 11. Infrared Sensors (2) (PCs). 12. Inside Control Board (1) (PCs). 13. Magnetic Limit Switch. The GPY600AC will handle gate weighting up to 600 kg and up to 8m / 26ft 12m if the proper installation procedures have been followed. The GPY600AC gate operator operates by forcing a drive rack by a drive gear. The entire configuration is shown in the diagram below. The gate operator must be installed on the inside of the gate. Gate preparation Be sure the gate is properly installed and slides smoothly before installing the GPY600AC sliding gate operator. The gate must be plumb, level, and move freely. Conduit In order to protect the cable, use PVC conduit for low voltage power cable and control wires. Conduit must be preset into the concrete when it is poured. Wires within the conduit shall be located or protected so that no damage can result from contact with any rough or sharp part. Concrete pad The base unit of the gate operator requires a concrete pad in order to maintain proper stability. The concrete pad should be approximately 450mm x 300mm x 200mm deep in order to provide for adequate weight and structure to insure proper stable installation. Anchors You can use anchor bolts, anchors, washers and nuts. These anchors must be set into the concrete when it is poured or you can use wedge anchors to fasten the operator. Operator base After the concrete has hardened, mount the gate operator base to the concrete pad. Verify that the base is properly leveled. The GPY600AC will handle gate weighting up to 600 kg / 1400 lbs and up to 8m / 26ft 12m if the proper installation procedures have been followed. The GPY600AC gate operator operates by forcing a drive rack by a drive gear. The entire configuration is shown in the diagram below. The gate operator must be installed on the inside of the gate. The base unit of the gate operator requires a concrete pad in order to maintain proper stability.